Kamry K1000 Plus ePipe Kit – Review

In this review I take a look at the K1000 Plus ePipe Kit from Kamrytech. The Kamry K1000 Plus ePipe Kit was supplied for the purpose of this review

That’s it! simply press the fire button and vape, while firing the fire button surround lights up. With 30 seconds of inactivity the device will go into sleep mode to save power but will fire from sleep mode with no noticeable delay!

_________________________________________________________________________

Using Independently

Both atomiser and battery can be used independently as it uses a standard 510 thread and connection and the drip tip fitting is a standard 510 also! Although other 510 drip tips fit absolutely fine in the K1000 Plus atomiser it has quite a deep hollow as the pipe style mouthpiece’s section that gets fitted inside the 510 fitment is a bit longer than with most 510’s so when using other atomisers with the epipe the pipe stem style drip tip doesn’t quite push all the way in but it works fine!

_________________________________________________________________________

Protections:

Low Power protection
Short Circuit Protection
Over 10s Protection

Charging

I found this let the device down as it took just over 2 and half hours to charge, it does support pass-through but the supplied cable is very short!

When first plugging the USB cable in the fire button surround flashes White 3 times before lighting solid White for the duration of the charge, once fully charged the light goes out!

_________________________________________________________________________

My Thoughts!

I have always liked the idea of an epipe but never actually got one because I suspected it would have wicking and leaking issues due to the atomiser being on it’s side but after using the K1000 Plus in the evenings since I received it and more extensively over the last 5 days neither have materialised as I haven’t had any leaking whatsoever and it’s wicked absolutely fine!

No specs are given for the coils apart from they are 0.5ohm but they are mesh and little flavour bangers and as I still have the same initial coil head in use means longevity is above average and also confirms there are no issues with wicking! I also like that the tank can be used independently and other atomizers with a 510 drip tip fitting can be used with the epipe battery and pipe style drip tip even if the drip tip doesn’t quite push all the way in.

It is a direct output device so the vape got weaker as the battery ran down, the drop off is a total of 14w which is quite a lot but it was gradual and even towards the end of the battery life it still gave a decent vape and for the most part i was pleasantly surprised what a nice smooth vape it gave. The airflow adjustment gives varying RDL and semi-RDL draws, you can’t really do a decent MTL but also not really a full on DL as even fully open there is some restriction!

The fire button does give some rattle but my main con is battery life and charging time. When I was using it just in the Evenings the 1100mAh battery was fine but since using it as my main device to more thoroughly test it then it has needed a couple of charges a day! It takes about 2 and half hours to charge which is quite sluggish for a 1100mAh, it does support pass-through though but if vaping while charging you might want to use a longer cable than the one supplied!

Looks like a pipe
Very well made
Zinc Alloy bowl
Finish shouldn’t fade due to process used
Stands at an angle so no stand needed
Fire button surround LED
Can be switched off
Goes into sleep mode after 30 seconds of inactivity
Protections
Ergonomic and fun to use
Despite direct output gives really good smooth vape even when nearing end of battery life
Supplied coil heads, flavour bangers
Above average coil longevity
Wicked surprisingly well
Suffered no leaking whatsoever
Adjustable airflow (Varying RDL and Semi-RDL draws)
4ml Capacity
Both atomiser and battery can be used independently

Cons

Direct output device (drop off in power) but still gives decent vape for entire life
1100mAh battery doesn’t make it suitable as main device
Sluggish charge rate
Fire button rattle
If glass breaks the whole atomiser will need replacing
Bottom fill, have to remove atomiser from battery to fill
Full specs not given with coils

I would once again like to thank Sourcemore for supplying the Kamry K1000 Plus ePipe Kit for the purpose of this review, thanks for reading and stay safe!

Kamry K1000 Plus ePipe Kit 1000mAh with 4ml K1000 Plus Atomizer